IPC Training and Publications

Australia's Only Licenced IPC Training Centre for ALL IPC programs - J-STD-001, A-610, A-600,A-620, 7711/21, CID and CID+


IPC Certified IPC Trainer (CIT) and Certified IPC Specialist (CIS) Courses
Next Courses:
J-STD-001 - course also in Brisbane Feb 2011
A-610 - course also in Bribane Feb 2011 - call 03 9568 0599 for Brisbane Course details.
7711/7721
A-600
IPC/WHMA-A-620
FOR IN HOUSE COURSES - call 03 9568 0599 for pricing

IPC TRAINING IN MALAYSIA, SINGAPORE, THAILAND AND THE PHILIPPINES -
Please call the SMCBA representative in SE Asia - Sem Au at SGM Management Group on Mobile: 09 4100198 or email sem.au@sgmmgroup.com

IPC Standards, Guidelines, Training Materials & Videos

The SMCBA is the distributor for IPC publications in Australia and New Zealand. IPC publications have been widely adopted by the electronics industry in this region since the SMCBA introduced the IPC standards to Australia in 1990.

Some of the "best selling" publications are listed below. Check with the SMCBA for the latest revisions of each of the standards and publications:
  • J-STD-001 Requirements for Soldered Electrical and Electronic Assemblies
  • IPC-A-610 Acceptability of Printed Board Assemblies
  • IPC-A-600 Acceptability of Printed Boards
  • IPC-7351 Generic Requirements for Surface Mount Land Pattern and Design Standard (replaced IPC-SM-782)
  • IPC-2221 Generic Standard on PWB Design (replaced IPC-D-275)
  • IPC-2222 Sectional Standard on PWB Design
  • IPC-2223 Sectional Design Standard for Flexible Printed Boards
  • IPC-2224 Sectional Standard for Design of PWB's for PC Cards
  • IPC-2225 Sectional Design Standard for Organic Multichip Modules (MCM-L) and MCM-L Assemblies
  • IPC-D-279 Design Guideline for Reliable Surface Mount Technology Printed Board Assemblies
  • IPC-DRM-18 Component ID Desk Reference Manual
  • IPC-DRM-PTH Through Hole Solder Joint Evaluation Desk Reference Manual
  • IPC-DRM-SMT Surface Mount Technology Desk Reference Manual
  • IPC-7711 Rework of Electronic Assemblies
  • IPC-7721 Repair and Modification of Printed Boards and Electronic Assemblies
Videos - An extensive range available for design through fab to assembly:
  • Introduction To Surface Mount Assembly
  • Introduction to Through-Hole Assembly
  • Hand Soldering
  • VReflow Soldering
  • Wave Soldering
  • ESD Control
  • Surface Mount Rework
  • Surface Mount Solder Joint Evaluation Series

These are just a few of the wide range of publications available through the SMCBA. For further information please contact the SMCBA by email to Andrew Pollock or by phone on (03) 9568 0599 or fax (03) 9568 0622.